Warwick TUBEPATH 10.1 Manuel de service Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 14
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
X-TREME
FRONT PANEL CONTROLS
INPUT socket to plug in a bass guitar.
GAIN control + CLIP LED to adjust the input level*.
-10 dB PAD switch to set the range of the GAIN control. Use it with high output basses.
COMPRESSOR switch + 2-colored ON/COMPRESS LED to compress the signal.
In position up the compressor is on, in middle position off, in down position it is
on if the EQ section is activated.
COMPRESSION control to set the compression ratio.
BOOST switch to activate a second volume level. In down position +2dB, in up position
+6dB, in middle poistion the boost is off. Activating the BOOST does automatic
ally activate the Compressor.*
EQ ON switch activates the EQ section*.
EQ BALANCE control to balance the volume level with EQ on and EQ off.*
VOICING SECTION:*
BOTTOM control to extend the low frequency range. Use this at lower volume settings or for
ultra low sounds. At higher volumes it might be better to reduce the low range.
CONTOUR control boosts lows and highs, while cutting mids.
GROWL control for boosting/cutting low mids.
ATTACK control for boosting/cutting presence.
EQ SECTION:*
BASS control to boost/cut deep frequencies.
MID FREQ. control to determine a frequency.
MID LEVEL control to boost/cut the frequency adjusted with the MID FREQ. control.
TREBLE control to boost/cut high frequencies.
MUTE switch + ON/MUTE LED cuts the signal from all outputs, except from the PHONES
socket, and activates the TUNER output (rear panel). In case of signal flow at the
power section (Input or Effects Return), there might appear a popping noise when
MUTE is switched. To avoid this, mute your strings and have effects like delays
muted when switching MUTE.
MASTER control determines the mains level.
PHONES socket for connecting a headphone (min 200 Ω)
POWER on/off switch for the Mains Power.
* Note: after adjusting the voicing section, the BOOST or activating the EQ section the Gain control needs to be adjusted that the level is under the
CLIP point.
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire